Op 11-8-2010 7:09, Chris Buechler schreef:
On Tue, Aug 10, 2010 at 5:08 PM, Fabricio Ferreira<[email protected]> wrote:
Thanks Everyone!
Actually I made it work, but not using the same monitoring address on both
interfaces.
Yeah you can't do that, as the monitor IP always is forced out only
one connection (I think the book is probably the only place that
documents that). 2.0 adds input validation to not allow such
configurations.
That probably means that the check I coded for 2.0 isn't kicking in.
I used to have input validation that would deny a monitor IP which was
used before.
Although I think it will fail in some fashion with multi dhcp wan where
the gateway is the same. I can probably easily test that.
Regards,
Seth
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
