Considering the amount of flaming about unsubscribe messages flying about when I joined this group I am more than a little hesitant to write this note. However, I will shortly be deprived of my broadband connection, and an E-mail list such as this one is a luxury I choose not to afford. You'll forgive me for this method of unsubscribing I hope when I inform you that this is my fith attempt to unsubscribe. All for of my previous attempts were in the prescribed manor. I am not a novice in the world of technology, but how to sucessfully unsubscribe from this group is a mystery to me. Perhaps the problem is not in the people trying to unsubscribe. Thank you for your help. Buddy ----- Original Message ----- From: [EMAIL PROTECTED] To: biofuel@yahoogroups.com Sent: Saturday, June 02, 2001 10:50 PM Subject: [biofuel] Re: Digest Number 472
You can see a photo of my shotgun condenser along with a description of how I build it on Tony Ackland's site. Go to: http://www.geocities.com/kiwi_distiller/ And then to: Photos and finally: Moonshine stills It is the one on the top named MooNShiNeR's Still. The shotgun is the best form of heat exchanger that I know of. Extremely efficient and can handle almost anything thrown at it. I got a huge industrial model in my shop made out of copper that weighs roughly 200 lbs. They can be made any size of course depending on the application. For the application mentioned before, a small version can be utilized to provide all the heat needed and then some. David, I concur, having used one to a good extent. Sam --- In [EMAIL PROTECTED], "David Reid" <[EMAIL PROTECTED]> wrote: > Greg, > Havnt followed you here. Are you talking about what Steve has done > or what I have suggested with the shotgun heat exchanger. You mentioned a > hose within a hose using insulated radiator hose. If you are talking about > this type of setup which is the most basic heat exchanger with the copper > tube inside the rubber hose with a tee either end it will work reasonably > satisfactorily but nowhere as quick or as fast as a shotgun heat exchanger. > These are basically the same principle multiplied a number of times so every > tube has a full 360 degree contact with the heating fluid and conduction is > very rapid. If the heat source of the heating fluid is hot enough it is > quite often possible to have cold fluid entering at one end and emerging > close to the initial temperature of the heating fluid in a very short > length. > B.r., David > ----- Original Message ----- > From: Greg Yohn <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Sunday, June 03, 2001 2:40 PM > Subject: RE: [biofuel] Digest Number 472 > > > > I know it sounds simple, but copper fittings are soldered together and > then > > the copper tubing is soldered in place forcing the coolant out the side > "T" > > fitting. Its much better than compression fittings and copper heats the > oil > > better than plastic tubing in transit to the fuel injectors. Hey, its so > > easy that I can do it!!!! Yahoo! Groups Sponsor Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Please do NOT send "unsubscribe" messages to the list address. To unsubscribe, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. [Non-text portions of this message have been removed] Biofuel at Journey to Forever: http://journeytoforever.org/biofuel.html Please do NOT send "unsubscribe" messages to the list address. To unsubscribe, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
