Funny about coke and phosphoric acid I guy showed me how well it cleaned the battery terminals of a .6MW generator. Had a pair of them with mighty nice terminals. :-) Never forgot that trick. Did not realize it was the phosphoric acid. But it tempered thirst for coke.
On Sun, Mar 21, 2010 at 7:00 PM, J. Forster <j...@quik.com> wrote: > Maybe Diet Coke or Coke Zero ?? > > -John > > ========== > > > [snip} > > > Legend has it you can solder stainless steel with Coca Cola, but the > > sugar and caramel make that unlikely. > > A compounding pharmacy may be able to sell you some. > > I hope that that helps, > > Cheers, Neville Michie > > > > > > > > > > On 22/03/2010, at 7:43 AM, paul swed wrote: > > > >> Were do you obtain a small amount of phosphoric acid???? > >> Also when I looked it up they said it was H3PO4. Doesn't sound like > >> the > >> same. > >> Is there a common use for it? > >> > >> On Sun, Mar 21, 2010 at 1:58 PM, randy hunt > >> <randy_hunt...@yahoo.com> wrote: > >> > >>> Try measuring a known length of the resistance wire, say 6 inches > >>> and then > >>> double. . . > >>> > >>> Randy > >>> > >>> Hi > >>> > >>> Next step would be to figure out what a reasonable ohms / foot number > >>> is. > >>> > >>> Bob > >>> > >>> > >>> On Mar 21, 2010, at 12:41 AM, Chuck Harris > >>> wrote: > >>> > >>>> HP just wound two parallel wires around the cylinder. They > >>> did not > >>>> twist. The wires at the entrance end of the solenoid went to > >>> the > >>>> electronics, the wires at the exit end of the solenoid were > >>> shorted > >>>> together... I think they used a crimp for the short. > >>>> > >>> > >>>> -Chuck Harris > >>>> > >>>> J. L. Trantham wrote: > >>>>> Do you > >>> make a 'twisted pair' and then wind that or just wind two parallel > >>>>> > >>> wires around the cylinder? > >>>>> Joe > >>>> > >>>> > >>> _______________________________________________ > >>>> time-nuts mailing list > >>> -- time-nuts@febo.com > >>>> To > >>> unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/ > >>> time-nuts > >>>> > >>> and follow the instructions there. > >>>> > >>> > >>> > >>> > >>> _______________________________________________ > >>> time-nuts mailing > >>> list -- time-nuts@febo.com > >>> To > >>> unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/ > >>> time-nuts > >>> and > >>> follow the instructions there. > >>> _______________________________________________ > >>> time-nuts mailing list -- time-nuts@febo.com > >>> To unsubscribe, go to > >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >>> and follow the instructions there. > >>> > >> _______________________________________________ > >> time-nuts mailing list -- time-nuts@febo.com > >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/ > >> time-nuts > >> and follow the instructions there. > > > > > > _______________________________________________ > > time-nuts mailing list -- time-nuts@febo.com > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.