Bob, Thanks for that, this Mouser project has all available parts. Do you know if the pots, trimmers, etc. are ones as suggested for the correct orientation, pin spacing, etc. as i believe there was some discussion regarding this in among the many postings on this topic?
Steve On 07/08/2010, Bob Camp <li...@rtty.us> wrote: > Hi > > I believe the project at: > > http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=8736DCEE10 > > is up to date in (no un-orderable parts). > > Bob > > -----Original Message----- > From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On > Behalf Of Didier Juges > Sent: Friday, August 06, 2010 8:36 AM > To: 'Discussion of precise time and frequency measurement' > Subject: Re: [time-nuts] What's the latest correct PICTIC II Mouser project? > > > I have not seen an answer to that question (for people in the US) ? > > I am waiting for the PWB, which I believe I paid for, and I am planning to > buy or make (have not looked into that yet) a PIC programmer, since it looks > like I may get some mileage out of that anyhow. > > No rush, but there is no good reason to delay either at that point. > > Thanks > > Didier > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > -- Steve Rooke - ZL3TUV & G8KVD The only reason for time is so that everything doesn't happen at once. - Einstein _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.