Hi Bob, I have the correct DIL 74175 so I can untick that item.
Steve On 07/08/2010, Bob Camp <li...@rtty.us> wrote: > Hi > > As far as I know all the parts are correct except the 74175. It is the soic > version. > > Bob > > > > On Aug 6, 2010, at 7:16 PM, Steve Rooke <sar10...@gmail.com> wrote: > >> Bob, >> >> Thanks for that, this Mouser project has all available parts. Do you >> know if the pots, trimmers, etc. are ones as suggested for the correct >> orientation, pin spacing, etc. as i believe there was some discussion >> regarding this in among the many postings on this topic? >> >> Steve >> >> On 07/08/2010, Bob Camp <li...@rtty.us> wrote: >>> Hi >>> >>> I believe the project at: >>> >>> http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=8736DCEE10 >>> >>> is up to date in (no un-orderable parts). >>> >>> Bob >>> >>> -----Original Message----- >>> From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On >>> Behalf Of Didier Juges >>> Sent: Friday, August 06, 2010 8:36 AM >>> To: 'Discussion of precise time and frequency measurement' >>> Subject: Re: [time-nuts] What's the latest correct PICTIC II Mouser >>> project? >>> >>> >>> I have not seen an answer to that question (for people in the US) ? >>> >>> I am waiting for the PWB, which I believe I paid for, and I am planning >>> to >>> buy or make (have not looked into that yet) a PIC programmer, since it >>> looks >>> like I may get some mileage out of that anyhow. >>> >>> No rush, but there is no good reason to delay either at that point. >>> >>> Thanks >>> >>> Didier >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >>> >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >> >> >> -- >> Steve Rooke - ZL3TUV & G8KVD >> The only reason for time is so that everything doesn't happen at once. >> - Einstein >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > -- Steve Rooke - ZL3TUV & G8KVD The only reason for time is so that everything doesn't happen at once. - Einstein _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.