Hi

Yes, I think the dither would just be a minor routine running on what ever you 
use to discipline the rubidium. Other than a disciplined environment I don't 
see a lot of  need for sub 7x10^-13 steps.

Bob



On Jan 29, 2012, at 9:12 AM, Magnus Danielson <[email protected]> 
wrote:

> On 01/29/2012 02:45 PM, Bob Camp wrote:
>> Hi
>> 
>> Very interesting.
>> 
>> It sounds like dithering would be needed to get down to parts in 10^-14. If 
>> we do that from an external device (PC / PIC / FPGA / whatever) it would be 
>> useful to know the delay between the serial command and the DDS update. The 
>> more variable the delay, the less accurate the dither.
> 
> Considering that you only need about 3 bits or so, and considering that the 
> internal step mechanism run with so low rate, achieving this should not be 
> all that hard really. It's not like there is a flashy GUI for the PIC to keep 
> up with. A little 8 pin PIC should pull it off with not too high effort.
> 
> Cheers
> Magns
> 
> _______________________________________________
> time-nuts mailing list -- [email protected]
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to