You can't use the square wave? You could put in a resonant circuit that will
select the fundamental but other issues arise, such as phase noise and harmonic
content. How much harmonic content can you tolerate?
There is a host of ways to do this job but much depends on your requirements.
Bob K6DDX
On Thursday, July 16, 2015 2:03 PM, skipp Isaham via time-nuts
<time-nuts@febo.com> wrote:
re: 10MHz Square to Sine Wave Conversion
The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like
to convert it to a sine wave and I am looking for suggestions and info re
any reasonable pre-made circuits and/or boards. No sense reinventing the
wheel if I can avoid it.
Otherwise I will start from scratch and make a new wheel....
Thank you in advance for your replies.
Regards,
skipp
skipp025 at yahoo dot com
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
