Hi The simple approach is to buffer it with a few ‘125 buffers in parallel. Then convert to sine wave with a T-network matching section. There are a lot of matching calculators on the web. Something in the 50 to 200 ohm input range and 50 ohm output is a reasonable way to go. More gates and higher power = more output. Lower input impedance = more output.
Bob > On Jul 16, 2015, at 1:49 PM, skipp Isaham via time-nuts <time-nuts@febo.com> > wrote: > > re: 10MHz Square to Sine Wave Conversion > > The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like > to convert it to a sine wave and I am looking for suggestions and info re > any reasonable pre-made circuits and/or boards. No sense reinventing the > wheel if I can avoid it. > > Otherwise I will start from scratch and make a new wheel.... > > Thank you in advance for your replies. > > Regards, > > skipp > > skipp025 at yahoo dot com > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.