Another admittedly low-budget way of heating both ends is to use a heat spreader. Solder a short piece of braid to one component end, fold it over the top of the part, and solder it to the other end. Heat the braid in the center, add solder until both ends are melted, and lift the combination off with tweezers. Sometimes a heavy enough copper wire bent around the part will also work as the heat spreader..
Bob LaJeunesse > Sent: Saturday, November 05, 2016 at 9:05 PM > From: "Andy ZL3AG via time-nuts" <time-nuts@febo.com> > To: "Discussion of precise time and frequency measurement" > <time-nuts@febo.com> > Subject: Re: [time-nuts] I love the smell of tantalum in the morning > > > Yes. Unless you're grinding it away with a dremel (which I wouldn't recommend > as far as chemical dust is concerned), nibbling away with sidecutters would > be trying to force the 2 ends of the component apart. That may be stressing > the pads they're soldered to, leading to a possible pad lifting at some stage. > > Any of the methods mentioned that heat both ends at the same time - allowing > the component to be wiped off the board - would have to be the best, > stress-wise. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
