Am 05.02.2017 um 04:29 schrieb Hal Murray:
b...@baylorhill.com said:
Where does pin three (P1) connect. I may have trashed both units. Are
schematics available.
I don't know of any schematics. I would take it apart and see if anything is
connected to any of the other pins on those connectors. Or measure the
resistance from the outside.
I also know of no schematics, but I took some photos when I made the 10
MHz output and the
distribution amplifier for mine. The power input seems quite simple.
Everything goes straight
into the DC/DC converter. Probably the input is not referenced to
ground. There are just some
chokes and a reservoir capacitor. There is a diode, too. It looks too
weak for use as a crowbar
or as a series diode.
<
https://www.flickr.com/photos/137684711@N07/31906174553/in/album-72157662535945536/
>
(GPS board removed)
regards, Gerhard
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.