Hi The power “brick” is a pretty standard Lucent part. The show up from time to time on the surplus market. The gotcha is that you may be able to buy a KS box for less than the asking price for the power brick.
There are no schematics on these devices other than what some people have traced out here and there. The input to the power brick is simple enough that it’s probably worth simply tracing out on the board. That will involve pulling the board completely out of the chassis (which is a pain). Once it’s out, some quick ohm meter checks between the power inputs and the labeled pins on the power converter will give you a pretty good idea of what goes where. There *might* be a pc board mounted fuse on there somewhere …. Bob > On Feb 4, 2017, at 8:54 PM, Roland Wm Buzz Ude <b...@baylorhill.com> wrote: > > I,m brand new to this forum. I need your help. While powering up a KS-24361 > set of units for the first time, my power plug for P1 was wired incorrectly!. > Pin one (P1) was plus 24 VDC; Pin three (P1) minus 24 VDC--this > should have been pin two Tried same connection on both L101 and L102, no > activity of any kind. Where does pin three (P1) connect. I may have trashed > both units. Are schematics available. Thanks W8BUZ > > --- > This email has been checked for viruses by Avast antivirus software. > https://www.avast.com/antivirus > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.