To add in some small manner to what Bob Camp said:
IIRC, the input is polarity protected by a diode or two. I think the input to
the brick is floated; i.e. neither of the two power leads is connected to
ground. The brick can be disassembled, if you're careful. The components,
except for the transformers are pretty standard stuff. On one of my units, I
had a blown cap and diode. It is SMT, though, so you'd need expertise in
working with that.
I find it hard to believe that the brick was blown, though. Have you verified
that you're powering the correct pins?
Bob
From: Bob Camp <kb...@n1k.org>
To: Discussion of precise time and frequency measurement <time-nuts@febo.com>
Sent: Sunday, February 5, 2017 9:53 AM
Subject: Re: [time-nuts] Power Problems Lucent KS-24361, L101 & L102
Hi
The power “brick” is a pretty standard Lucent part. The show up from time to
time
on the surplus market. The gotcha is that you may be able to buy a KS box for
less
than the asking price for the power brick.
There are no schematics on these devices other than what some people have traced
out here and there. The input to the power brick is simple enough that it’s
probably
worth simply tracing out on the board. That will involve pulling the board
completely
out of the chassis (which is a pain). Once it’s out, some quick ohm meter
checks between
the power inputs and the labeled pins on the power converter will give you a
pretty
good idea of what goes where. There *might* be a pc board mounted fuse on there
somewhere ….
Bob
> On Feb 4, 2017, at 8:54 PM, Roland Wm Buzz Ude <b...@baylorhill.com> wrote:
>
> I,m brand new to this forum. I need your help. While powering up a KS-24361
> set of units for the first time, my power plug for P1 was wired incorrectly!.
> Pin one (P1) was plus 24 VDC; Pin three (P1) minus 24 VDC--this
> should have been pin two Tried same connection on both L101 and L102, no
> activity of any kind. Where does pin three (P1) connect. I may have trashed
> both units. Are schematics available. Thanks W8BUZ
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> time-nuts mailing list -- time-nuts@febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
