An update about this thread... It turns out that OP (Andre) would like the readings of his vintage Black Star (UK) Nova 2400[X] 8-digit 2.4 GHz bench frequency counter to be accurate and stable to the 8th digit. That's all. The internal XO or TCXO is not good enough for that last digit or two. Not to mention the cal date is 1996.
So the good news is that he is *not* embarking on a life-long project to build his own atomic clock. This thread is just a newbie looking for a simple answer to an accuracy / stability / calibration question. His counter has a BNC for external timebase, so ... I think it would help him if any UK/EU time-nuts: - have a 1e-9 or 1e-10 level OCXO to spare -- which he would have to calibrate, or - can help him locate a surplus telecom Rb -- inherently good enough that calibration is not even required, or - point him to a cheap newbie-friendly 10 MHz GPSDO -- if his environment would make that possible and reliable. I would guess that a mere 8-digits of accuracy/stability should cost no more than 100 these days. If you can help, please send him email, off-list. Again, OP is not looking for laboratory-grade accuracy or to build his own atomic clock from scratch. It's just an 8 digit counter. /tvb ----- Original Message ----- From: "Andre" <an...@lanoe.net> To: <time-nuts@febo.com> Sent: Tuesday, April 11, 2017 12:31 AM Subject: [time-nuts] Re. DIY atomic "resonator" > Hi all. > > As a first step, I wanted to build a specific hydrogen line (1.420 GHz) > preamp. > > Seems that some fluorescent tube starters do emit a very brief burst at > around 1.4 GHz > > during a specific portion of the initial switch-on surge when cold and > actually observed this here. > > > Also relevant, this same preamp can be used for GPS and if you're living in > an RF proof flat > > with only one good radio station its hard to get any signal. > > > Has anyone else either built an atomic clock around a bare Rb lamp module > "core" or attempted > > to make a hydrogen maser? > > It would be a fascinating project to integrate SDR as these are (with > modifications) very accurate > > and can be used to fine tune a lot of the oscillators etc with less hassle. > > > Thanks, -Andre in Guernsey _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
