Chris, are you sure the RX light is blinking and not the TX? When you turn it on, you should see the TX light blinking and the PPS with Power on as well.
> On Jul 3, 2017, at 9:52 PM, Chris Waldrup <kd4...@gmail.com> wrote: > > Has anyone else received a unit they can't get to work? > I got my unit finally boxed up a few weeks back. The PPS LED flashes and > power LED and RXD LED's light but the TxD doesn't. > I've ordered replacement MAX chips and 74ACT04 chips from Digi-Key but this > didn't solve the problem. > As a next step I've found a Oncore M12 board on eBay coming from China and > this should come in a few weeks. > No serial communications unfortunately. > I've also tried swapping pins 2 and 3 on the DB9 just in case RX and TX were > swapped (although I had originally built the cable as per the schematic with > the kit) but still no luck. > Thanks for any comments. > > Chris > KD4PBJ > >> On Apr 29, 2017, at 11:10 AM, Chris Albertson <albertson.ch...@gmail.com> >> wrote: >> >> On this product people are going to want holes drilled and I think a "D" >> shape hole for the DB type connector. The holes would allow easy clamping >> but in a two step operation. If I were making these I'd first clamp the >> stock over a pair of 123 blocks, mill the holes, then after I hade a batch >> of these made, hole the holes to hold the part a fixture and then mill the >> edges. >> >> But that said, I could make a pair of these by hand with hack saw, file and >> drill press in about 15 minutes. >> >> >> >>> On Fri, Apr 28, 2017 at 1:41 PM, Jerry Hancock <je...@hanler.com> wrote: >>> >>> >>> Generally, the way I mill plates such as these is I surface a piece of >>> scrap and then glue (using superglue) the stock down onto the scrap. I can >>> then machine around the edges without worrying about clamping. With >>> pockets though, the torque even when ramping down might break the part >>> loose. >>> >> >> -- >> >> Chris Albertson >> Redondo Beach, California >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.