Rick, It might be an adventure but ebay - doukstore has a AD9959 Radio Frequency RF Signal Source Generator 4-Channel DDS Module DC5V for 50.99 and a DDS Module Driver Board LCD for AD9854 / AD9954 / AD9833 / AD9834 / AD9851 control board at 27.99 with push buttons and a LCD screen to set the outputs. They also have a number of other DDS modules.
I have no idea what the quality is and I doubt there are English manuals or any schematics but for 78 bucks delivered it might suit. Bob Darby -----Original Message----- From: time-nuts [mailto:time-nuts-boun...@febo.com] On Behalf Of Richard (Rick) Karlquist Sent: Wednesday, December 13, 2017 3:03 PM To: Discussion of precise time and frequency measurement <time-nuts@febo.com> Subject: [time-nuts] Simple open source microcontroller solution to tune DDS needed I need a very simple controller to tune a DDS with up/down switches (imagine setting the time on a clock). A DDS chip, such as an AD9836 would go on a PC board and a couple of pushbuttons would tell the controller to tune up or down. Before reinventing this wheel, I thought I would see if anyone knows of a similar solution that can be leveraged. What I would like is both hardware and software, where the software could be edited to accommodate the up/down buttons. A last resort would be to write software from scratch. My software skills are extremely limited. Cutting and pasting code might work for me. I need to be able to embed this onto an existing PC board. I can't use a preexisting "daughter" card, other than to copy the design of the card. Rick Karlquist N6RK _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.