Rick Please contact me off list we did a board for Corby to be used with the HP Rb using a PIC but I would have to better understand your needs to figure out what board to use. Bert Kehren In a message dated 12/13/2017 4:06:01 PM Eastern Standard Time, artgod...@gmail.com writes:
It's a bit bizarre that it uses Basic. I just remember my local ARC using it as a project sometime ago. Possibly in the 20th century. :) On Wed, Dec 13, 2017 at 9:03 PM, Richard (Rick) Karlquist < rich...@karlquist.com> wrote: > This looks like a very good starting point. It's a superset > that I can just simplify. > > Rick > > > On 12/13/2017 12:10 PM, Adrian Godwin wrote: > >> Maybe this one ? >> >> http://www.qsl.net/pa3ckr/bascom%20and%20avr/ad9951/index.html >> >> There are probably many others >> >> >> On Wed, Dec 13, 2017 at 8:03 PM, Richard (Rick) Karlquist < >> rich...@karlquist.com> wrote: >> >> I need a very simple controller to tune a DDS with up/down >>> switches (imagine setting the time on a clock). A DDS >>> chip, such as an AD9836 would go on a PC board and a couple >>> of pushbuttons would tell the controller to tune up or >>> down. >>> >>> Before reinventing this wheel, I thought I would see if >>> anyone knows of a similar solution that can be leveraged. >>> What I would like is both hardware and software, where >>> the software could be edited to accommodate the up/down >>> buttons. A last resort would be to write software from >>> scratch. My software skills are extremely limited. >>> Cutting and pasting code might work for me. >>> >>> I need to be able to embed this onto an existing PC board. >>> I can't use a preexisting "daughter" card, other than >>> to copy the design of the card. >>> >>> Rick Karlquist >>> N6RK >>> >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to https://www.febo.com/cgi-bin/m >>> ailman/listinfo/time-nuts >>> and follow the instructions there. >>> >>> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/m >> ailman/listinfo/time-nuts >> and follow the instructions there. >> >> >> _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.