Magnus, Why not just clock a good DDS (AD9854) with the reference frequency, and run its I & Q outputs into the motor via suitable LP filters and some power gain? You might need to periodically alternate between two different output frequencies to get the desired rotation speed (as with a fractional N divider), but with the 48-bit DDS I'd think that this would work well. After all, the magnetics in a motor are not all that accurate anyway- one cannot get perfection in avoiding salient pole effects etc.
Dana On Tue, Dec 24, 2019 at 6:02 PM Magnus Danielson <mag...@rubidium.se> wrote: > Hi, > > I realize that I lack a microstepper. Consider that I have a stable and > low-noise 5 or 10 MHz but I want to resynthesize to correct frequency > and do phase-steps, and doing so without too much loss of noise. > > This has traditionally been done using a variation of techniques, but if > we would use some of the things that happened lately, pretty OK > performance should be possible to achieve without too much hardware. > > OK, so after a discussion with Bob, here is one sketch for a > possibility, just to toss one proposal to crush into pieces and propose > improvements or better versions. > > So, consider using a modern Silabs chip clocked from an oscillator, > producing a offset generator with I/Q and then do an I/Q mixdown to a > beat frequency, which is digitized by a pair of ADCs. A pair of DACs > produces I/Q which is used to mixed to produce the output signal using > the signals from the Silab. The ADCs/DACs can be either be fed to some > CPU platform or FPGA. With this platform one can choose to servo the > reference oscillator, or just modify the beat received. Maybe use a > Raspberry Pi as platform. Rotating the vector and steering the rate of > rotation should not be extremely hard to do. The input vector can be > added internally or used to steer the oscillator. Either way, the in > loop noise from the Silabs will be fairly well suppressed since it only > acts as a transfer oscillator. > > So, suggestions, thoughts and improvements? > > God Jul and Merry Christmas! > > Cheers, > Magnus > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.