In message <[EMAIL PROTECTED]> you wrote: > > I would prefer to move this init code not into the board code but into the > platform/cpu code. Speaking for PPC4xx, here all configuration I know of have > the same init code. And copying this into all board ports instead on one > place in the cpu directory seems "imperfect".
But the ethernet configuration *is* actually bord dependent. A board may or may not use all the ethernet interfaces present on a processor, or it may have additional network controllers attached for example to the PCI bus, etc. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] If it went on at this rate, in several billion years he'd be rich beyond his wildest dreams! - Terry Pratchett, _Soul Music_ ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
