On Saturday 22 March 2008, Wolfgang Denk wrote: > In message <[EMAIL PROTECTED]> you wrote: > > I would prefer to move this init code not into the board code but into > > the platform/cpu code. Speaking for PPC4xx, here all configuration I know > > of have the same init code. And copying this into all board ports instead > > on one place in the cpu directory seems "imperfect". > > But the ethernet configuration *is* actually bord dependent. A board > may or may not use all the ethernet interfaces present on a > processor, or it may have additional network controllers attached for > example to the PCI bus, etc.
So you vote for adding this code to more than 80 4xx boards that all would use the same code here? I don't like this. I would prefer one instance in the cpu directory which could be overridden if needed by a board specific version. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
