In message <[EMAIL PROTECTED]> you wrote: > > I found out, why the Generic MACB MII driver for the AT91SAM9260 doesn´t > work. ... > Instead of lines PA23 and PA24 you have to use > > at91_set_B_periph(AT91_PIN_PA10, 0); //ETX2 > at91_set_B_periph(AT91_PIN_PA11, 0); //ETX3 > > which have the same abilites.
can you please submit a proper patch? See http://www.denx.de/wiki/UBoot/Patches for instructions. > Hopefully someone from denx.de could do that and I hope for a positive > reply - Thank you This will behandled by the AT91 custodian - but please submit a proper patch... Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] He'd been wrong, there _was_ a light at the end of the tunnel, and it was a flamethrower. - Terry Pratchett, _Mort_ ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
