Manuel Sahm wrote: > if I apply the patch with: > > patch -p1 < patchat91.diff > > some messages occur, is this correct ? > > > (Stripping trailing CRs from patch.) > patching file board/atmel/at91sam9260ek/at91sam9260ek.c > patch unexpectedly ends in middle of line > Hunk #1 succeeded at 183 with fuzz 2 (offset -5 lines).
it is very likely that these messages occur because the patch was incorrectly saved from the email body. This patch applies cleanly against top of our u-boot git tree. > The description is correct - PA23 and PA24 are connected to the TWI > EEPROM an the DevBoard at91sam9260ek. > The patch works well. > Here the signed-off line: > > Signed-off-by: Manuel Sahm <[EMAIL PROTECTED]> Thanks, I will repost the patch again. > Another problem is, that the same error is in the official kernel tree > in the file at91sam9260ek_devices.c ?! > Although the error is still in the kernel, a modification of the uboot > file at91sam9260ek.c is enough to get ethernet working ? if the kernel resets Peripheral B pin configuration, then ethernet will stop working, I think. This should be fixed in the kernel code, too. Best regards, Anatolij ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
