On Monday 03 November 2008, 조기성 wrote: > I’m using ppc440Ep and using u-boot1.3.3 > > I’m using u-boot1.1.3 with Yosemite configuration.
Please use the latest version from the DENX git repository. > When I boot with Yosemite conf , it stops SDRAM:256 , it’ shows cpu, pci > conf So it most likely crashed upon relocation into SDRAM. So its an SDRAM configuration problem. > My New Board configuration is only different SDRAM Size and Flash Size. > > > Where can I modify my Yosemite configuration. > > Init.S and Yosemite.h Yosemite uses a board specific SDRAM init routine. I suggest that you use the common DDR2 init code by enabling it in your board config header (include/configs/board.h): #define CONFIG_SDRAM_BANK0 1 /* init onboard DDR SDRAM bank 0*/ You can also define CONFIG_SYS_SDRAM_TABLE if you have an uncommon SDRAM configuration. What's the difference of your SDRAM configuration? Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot