Dear Afzal Nadirshah,
In message <174230991e95d743b0c91df471ef44e8434393e...@mtw02msg02.mindtree.com>
you wrote:
>
> Thanks for the reply. I looked into the file that you mentioned and also
> the README as well as the POST directory.
> I could not go into the details very minutely. From this I have
> understood that
> 1. Support for POST for canyonlands board is present.
No. That's not quite correct. There is no specific POST support for
the PPC460 nor for the Canyonlands board.
There is generic support for 4xx which has been inplemented for and
tested on 440EPx intensively, and which has been enabled on other
boards as well without noticing any obvious problems.
If you need POST support for the 460, you will have to:
- go through the 460 specific processor features like special
registers etc. anc check if (1) the existing code is still correct
for the 460 and (2) if it covers all the features that should be
tested
- go through board support for canyonlands and adapt the configuration
for POST (like I2C addresses to verify, etc.)
> 2. To enable POST for canyonlands board, I only have to define the required
> macros.
No, this is not sufficient. You have to check the processor and the
board support. And you have to test this, then. This is not as
trivial as it might seem. Good POST requires a really intimate
understanding of all parts of the hardware involvec, processor,
board, etc.
> 3. I do not have to add / modify code to test the peripherals on the
> canyonlands board.
I think it is likely that you have to do that, if you want to do it
right.
> Could you please let me know if I have understood it correctly?
No, your view was too simplistic.
> Thanks a lot. I am hard pressed for time and your suggestions are invaluable.
Doing good POST and lack of time should never be used in the same
context - they are on opposite ends of the scale.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
The use of Microsoft crippleware systems is a sin that carries with
it its own punishment.
-- Tom Christiansen in <6bo3fr$pj...@csnews.cs.colorado.edu>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
