This patch adds FEC support for Vybrid MVF600 platform. In function fec_open(), RCR register is only set as RGMII mode. But RCR register should be set as RMII mode for MVF600 platform. This configuration is already done in fec_reg_setup(), so this piece of code could just leave untouched the FEC_RCNTRL_RGMII / FEC_RCNTRL_RMII / FEC_RCNTRL_MII_MODE bits.
Signed-off-by: Alison Wang <b18...@freescale.com> --- Changes in v3: - Remove the changes for FEC_RCNTRL_RGMII / FEC_RCNTRL_RMII / FEC_RCNTRL_MII_MODE bits, as they are already set in fec_reg_setup() Changes in v2: - Use common FEC driver fec_mxc.c drivers/net/fec_mxc.c | 4 +--- 1 file changed, 1 insertion(+), 3 deletions(-) diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index 4dbcdca..da95e28 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -516,9 +516,7 @@ static int fec_open(struct eth_device *edev) #ifdef FEC_QUIRK_ENET_MAC { u32 ecr = readl(&fec->eth->ecntrl) & ~FEC_ECNTRL_SPEED; - u32 rcr = (readl(&fec->eth->r_cntrl) & - ~(FEC_RCNTRL_RMII | FEC_RCNTRL_RMII_10T)) | - FEC_RCNTRL_RGMII | FEC_RCNTRL_MII_MODE; + u32 rcr = readl(&fec->eth->r_cntrl) & ~FEC_RCNTRL_RMII_10T; if (speed == _1000BASET) ecr |= FEC_ECNTRL_SPEED; else if (speed != _100BASET) -- 1.8.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot