Hi Alison, On Tuesday, May 21, 2013 11:02:58 AM, Alison Wang wrote: > This patch adds FEC support for Vybrid MVF600 platform. > > In function fec_open(), RCR register is only set as RGMII mode. But RCR > register should be set as RMII mode for MVF600 platform. > This configuration is already done in fec_reg_setup(), so this piece of > code could just leave untouched the FEC_RCNTRL_RGMII / FEC_RCNTRL_RMII / > FEC_RCNTRL_MII_MODE bits. > > Signed-off-by: Alison Wang <b18...@freescale.com> > --- > Changes in v3: > - Remove the changes for FEC_RCNTRL_RGMII / FEC_RCNTRL_RMII / > FEC_RCNTRL_MII_MODE bits, as they are already set in fec_reg_setup() > > Changes in v2: > - Use common FEC driver fec_mxc.c > > drivers/net/fec_mxc.c | 4 +--- > 1 file changed, 1 insertion(+), 3 deletions(-) > > diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c > index 4dbcdca..da95e28 100644 > --- a/drivers/net/fec_mxc.c > +++ b/drivers/net/fec_mxc.c > @@ -516,9 +516,7 @@ static int fec_open(struct eth_device *edev) > #ifdef FEC_QUIRK_ENET_MAC > { > u32 ecr = readl(&fec->eth->ecntrl) & ~FEC_ECNTRL_SPEED; > - u32 rcr = (readl(&fec->eth->r_cntrl) & > - ~(FEC_RCNTRL_RMII | FEC_RCNTRL_RMII_10T)) | > - FEC_RCNTRL_RGMII | FEC_RCNTRL_MII_MODE; > + u32 rcr = readl(&fec->eth->r_cntrl) & ~FEC_RCNTRL_RMII_10T; > if (speed == _1000BASET) > ecr |= FEC_ECNTRL_SPEED; > else if (speed != _100BASET)
Reviewed-by: Benoît Thébaudeau <benoit.thebaud...@advansee.com> Best regards, Benoît _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot