Dear Dave Kucharczyk, On Wed, Feb 25, 2015 at 11:08 PM, DaveKucharczyk <david.kucharc...@gmail.com> wrote: > Fabio Estevam-2 wrote >> Also, you said that your 512MB board version works fine, but the 256MB >> fails. >> >> I suppose you are using two different binaries for each board, right? >> You can't have a single binary for the two boards, unless you use the >> SPL approach. > > Fabio, we use one binary. It has runtime memory discovery via gpio's > (resistor reads). DRAM size is reported correctly from both boards. It just > hangs on the 256MB board. > > We do not have SPL setup.
You should try with 2015.01 as Fabio suggested. Also, check the CONFIG_SYS_TEXT_BASE of your board. From your log, I'm wondering if it's not set too high, resulting in an overlap of the pre- and post-relocation addresses occupied by your binary in the 256-MiB case. Best regards, Benoît _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot