On 05/20/2016 12:34 PM, Carlo Caione wrote:
> On 20/05/16 11:58, Robert Gadsdon wrote:
>> On 05/20/2016 01:07 AM, Carlo Caione wrote:
>>> On 20/05/16 08:27, Carlo Caione wrote:
>>>> On 19/05/16 21:51, Robert Gadsdon wrote:
>>>>> Applied this on my Odroid C2, and it worked OK when installed on the
>>>>> SDcard, but failed when installed on the eMMC module:
>>> Oh, reading this again you meant that you put u-boot directly on the
>>> eMMC? Ok then, something is wrong when using the driver with the eMMC.
>>>
>>> Yes, I installed it directly on the eMMC, using the micro-sd adapter,
>>> and following the same instructions as for the SDcard..
> Could you try with this patch?
>
> diff --git a/board/hardkernel/odroid-c2/odroid-c2.c
> b/board/hardkernel/odroid-c2/odroid-c2.c
> index 34b9a95..ab78328 100644
> --- a/board/hardkernel/odroid-c2/odroid-c2.c
> +++ b/board/hardkernel/odroid-c2/odroid-c2.c
> @@ -80,6 +80,11 @@ U_BOOT_DEVICE(meson_mmc) = {
> .platdata = &gxbb_sd_platdata[CONFIG_MMC_MESON_SD_PORT],
> };
>
> +U_BOOT_DEVICE(meson_emmc) = {
> + .name = "meson_mmc",
> + .platdata = &gxbb_sd_platdata[2],
> +};
> +
> static void meson_mmc_pinmux_setup(unsigned int port)
> {
> switch (port) {
>
> Thanks,
Patch applied, and now the eMMC is detected OK:
=> mmc info
Device: <NULL>
Manufacturer ID: 15
OEM: 100
Name: BGND3
Tran Speed: 52000000
Rd Block Len: 512
MMC version 5.0
High Capacity: Yes
Capacity: 29.1 GiB
Bus Width: 8-bit
Erase Group Size: 512 KiB
HC WP Group Size: 8 MiB
User Capacity: 29.1 GiB WRREL
Boot Capacity: 4 MiB ENH
RPMB Capacity: 4 MiB ENH
... And I can load/boot the Kernel (as far as the /dev/mmc... prompt..)
Thanks!
Robert Gadsdon.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
