well I don't need to have the Ethernet running for the shipped product...
but I would like to use it in production test of the next batch - so if I can avoid an extra issue of u-boot I will.... D. > > But I'm running out of time to ship some prototypes tomorrow, and > > this is > > my last major issue with them, so could I throw myself on the > > mercy of > > the assembled wisdom please? Maybe someone will say - you stupid > > person, > > you need to change this line to that.... > > I don;t say that, but I do say this: With such a short deadline, you > should have hired an expert a couple of days (or weeks) ago. > > > Yes, I know the very latest u-boot sources can do similar, but I > > had to > > freeze on 2008-10 because of the saveenv issue. Too late to > > update now. > > This is unlogical. Instead of updating and fixing "the saveenv > issue" > (whatever this is) you are using old code - where you now have to > fix > "the PHY issue". Is this any better? > > ... > > the linux startup says: > > > > eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:10, > > irq=-1) > > eth1: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:00, > > irq=-1) > > > > now we have strapped PHYAD4 high, so the 2 phys should have > > addresses > > binary 10000 and 10001 > > > > I can't see any relationship between 0:10 and 1:00 and 10000 and > > 10001 > > !!! > ... > > well maybe - the first one looks right - binary 10000 is hex 10 > > but the other port should be on hex 11, not hex 0!!!!!! > > Maybe your haredware is not what you think it is? > > > but under u-boot > > > > in my file derived from ATNGW10.c I have > > > > void board_init_info(void) > > { > > gd->bd->bi_phy_id[0] = 0x01; > > gd->bd->bi_phy_id[1] = 0x03; > > } > > I can't see any relationship between 0x01 and 0x03 and 10000 and > 10001 > (or 0:10 and 1:00 either). Maybe you try these instead? > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev > Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, > Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: > w...@denx.de > Even if you can deceive people about a product through > misleading > statements, sooner or later the product will speak for itself. > - Hajime Karatsu > David Collier www.dexdyne.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot