On Tue, Jul 31, 2018 at 11:15 AM, Icenowy Zheng <icen...@aosc.io> wrote: > > > 于 2018年7月31日 GMT+08:00 下午1:42:46, Jagan Teki <ja...@amarulasolutions.com> 写到: >>On Sun, Jul 29, 2018 at 6:54 PM, Icenowy Zheng <icen...@aosc.io> wrote: >>> 在 2018-07-27五的 18:48 +0530,Jagan Teki写道: >>>> On Thu, Jul 26, 2018 at 12:35 PM, Icenowy Zheng <icen...@aosc.io> >>>> wrote: >>>> > >>>> > >>>> > 于 2018年7月26日 GMT+08:00 下午3:02:50, Jagan Teki < >>>> > ja...@amarulasolutions.com> 写到: >>>> > > On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icen...@aosc.io> >>>> > > wrote: >>>> > > > This patchset trys to add support for Allwinner H6 SoC to U- >>>> > > > Boot. >>>> > > > >>>> > > > Allwinner H6 is a quite new Allwinner SoC, with several parts >>>> > > > changed >>>> > > >>>> > > a >>>> > > > lot (memory map, DRAM controller, CCU, so on). The position >>>> > > > which SPL >>>> > > > will be loaded (SRAM A1) also changed to 0x20000. >>>> > > > >>>> > > > The Pine H64 board support comes with this patchset, as this >>is >>>> > > > the >>>> > > > first H6 board that I can get (being early bird). >>>> > > > >>>> > > > Icenowy Zheng (13): >>>> > > > sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS >>>> > > > sunxi: add basic memory map definitions of H6 SoC >>>> > > > sunxi: change RMR64's RVBAR address for H6 >>>> > > > sunxi: change ATF position for H6 >>>> > > > sunxi: add config for SPL at 0x20000 on H6 >>>> > > > sunxi: change GIC address on H6 >>>> > > > sunxi: add clock code for H6 >>>> > > > sunxi: use sun6i-style watchdog for H6 >>>> > > > sunxi: add UART0 setup for H6 >>>> > > > sunxi: add MMC support for H6 >>>> > > > sunxi: add DRAM support to H6 >>>> > > > sunxi: add support for Allwinner H6 SoC >>>> > > > sunxi: add support for Pine H64 board >>>> >>>> Reviewed-by: Jagan Teki <ja...@openedev.com> >>> >>> Do you consider merge it now? >> >>Yes, but there is a comment about kconfig move [1], I'm OK to send the >>change later since it can effect all SoC. > > Yes I suppose so.
Thanks. > > Also apply for the DM MMC change. Which change, can you point? > > BTW Are you working on some DM clock driver? Yes. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot