Hi Txema, On Friday 23 April 2010 10:36:24 txema lopez wrote: > > IIRC, then you problem was more related to using an 8bit wide chip (chip- > > width) on an 16bit port-width, > > Yes, it is our board flash layout.
OK. So you are using 2 chips interleaved on this 16bit bus (one on lower 8bits and one on higher 8bits), right? > > than being a specific Numonyx issue. Correct? > > But the same board with a Spansion S29GL flash is fully supported by > U-Boot, so, I think It is a Numonyx issue. I see. Did you check the Linux MTD drivers, if there is a Numonyx special handling here? Thanks. Cheers, Stefan -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: off...@denx.de _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot