> Subject: [PATCH v1 07/11] DTS: Add imx6q-display5-u-boot.dtsi file with
> u-boot specific properties
>
> This file setups UART5 based serial to be used as pre-relocation console in
> the
> U-Boot proper.
>
> On purpose pinux configuration is omitted here as it has been already done in
> SPL. For early pre-relocation code we only need the serial device from DTS.
>
> Signed-off-by: Lukasz Majewski <lu...@denx.de>
> ---
>
> arch/arm/dts/imx6q-display5-u-boot.dtsi | 44
> +++++++++++++++++++++++++++++++++
> 1 file changed, 44 insertions(+)
> create mode 100644 arch/arm/dts/imx6q-display5-u-boot.dtsi
>
> diff --git a/arch/arm/dts/imx6q-display5-u-boot.dtsi
> b/arch/arm/dts/imx6q-display5-u-boot.dtsi
> new file mode 100644
> index 0000000000..b942218b7a
> --- /dev/null
> +++ b/arch/arm/dts/imx6q-display5-u-boot.dtsi
> @@ -0,0 +1,44 @@
> +// SPDX-License-Identifier: GPL-2.0+
> +/*
> + * Copyright 2019
> + * Lukasz Majewski, DENX Software Engineering, lu...@denx.de
> + *
> + * SPDX-License-Identifier: GPL-2.0+ or X11
> + */
> +
> +/*
> + * The minimal augmentation DTS U-Boot file to allow UART5
> + * configuration in the pre-relocation stage of U-Boot
> + * proper.
> + *
> + * As the same UART is already configured in SPL, we don't need
> + * setup pinmux for it again.
> + */
> +
> +/ {
> + aliases {
> + mmc0 = &usdhc4;
> + };
> +
> + soc {
> + u-boot,dm-pre-reloc;
> +
> + aips-bus@2100000 {
> + u-boot,dm-pre-reloc;
> + };
> + };
> +
> + chosen {
> + stdout-path = &uart5;
> + };
> +};
> +
> +&i2c3 {
> + at24@50 {
> + u-boot,i2c-offset-len = <2>;
> + };
> +};
> +
> +&uart5 {
> + u-boot,dm-pre-reloc;
> +};
Reviewed-by: Peng Fan <peng....@nxp.com>
> --
> 2.11.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
