This patch enables the BBT in NAND on the AT91SAM based GARDENA smart Gateway. This is especially important, since the Linux driver also enables this option and uses the BBT table pages. Without setting this option, U-Boot will try to re-use these pages again (e.g. UBI).
Signed-off-by: Stefan Roese <s...@denx.de> Cc: Eugen Hristev <eugen.hris...@microchip.com> Cc: Tom Rini <tr...@konsulko.com> --- Eugen, I would advise you to double-check, if your AT91 based boards using NAND also have this BBT option enabled in Linux. If yes, its definitely necessary to enable it in U-Boot as well to match the same layout. configs/gardena-smart-gateway-at91sam_defconfig | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) diff --git a/configs/gardena-smart-gateway-at91sam_defconfig b/configs/gardena-smart-gateway-at91sam_defconfig index c495ba4612..4a2cc331a6 100644 --- a/configs/gardena-smart-gateway-at91sam_defconfig +++ b/configs/gardena-smart-gateway-at91sam_defconfig @@ -17,6 +17,7 @@ CONFIG_DEBUG_UART_BASE=0xfffff200 CONFIG_DEBUG_UART_CLOCK=132000000 CONFIG_SMBIOS_PRODUCT_NAME="at91sam9x5ek" CONFIG_DEBUG_UART=y +CONFIG_SPL_TEXT_BASE=0x300000 CONFIG_FIT=y CONFIG_NAND_BOOT=y CONFIG_BOOTDELAY=3 @@ -24,7 +25,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(bootstrap)ro,768k(uboot)ro,256k(env_redundant),256k(env),512k(dtb),6M(kernel)ro,-(rootfs) rootfstype=ubifs ubi.mtd=6 root=ubi0:rootfs rw" CONFIG_SYS_CONSOLE_IS_IN_ENV=y CONFIG_SYS_CONSOLE_INFO_QUIET=y -CONFIG_SPL_TEXT_BASE=0x300000 CONFIG_SPL_SYS_MALLOC_SIMPLE=y CONFIG_SPL_SEPARATE_BSS=y # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set @@ -66,7 +66,6 @@ CONFIG_AT91_GPIO=y CONFIG_LED=y CONFIG_LED_GPIO=y # CONFIG_MMC is not set -# CONFIG_SYS_NAND_USE_FLASH_BBT is not set CONFIG_NAND_ATMEL=y CONFIG_SPL_GENERATE_ATMEL_PMECC_HEADER=y CONFIG_DM_ETH=y -- 2.23.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
