Chips attached to the RSB bus require an initialization command before
they can be used. (Specifically, this command programs the chip's
runtime address.) The driver does this in its .probe_chip hook, under
the assumption that .probe_chip is called during child probe. This is
not the case; .probe_chip is only called by dm_i2c_probe, which is
intended for use by board-level code, not for chips with OF nodes.
Since this initialization command must be run before a child chip can be
used, do it before probing each child.
Signed-off-by: Samuel Holland <sam...@sholland.org>
---
drivers/i2c/sun8i_rsb.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/i2c/sun8i_rsb.c b/drivers/i2c/sun8i_rsb.c
index 716b245a00..0681e398f7 100644
--- a/drivers/i2c/sun8i_rsb.c
+++ b/drivers/i2c/sun8i_rsb.c
@@ -252,11 +252,12 @@ static int sun8i_rsb_probe(struct udevice *bus)
static int sun8i_rsb_child_pre_probe(struct udevice *child)
{
struct dm_i2c_chip *chip = dev_get_parent_plat(child);
+ struct udevice *bus = child->parent;
/* Ensure each transfer is for a single register. */
chip->flags |= DM_I2C_CHIP_RD_ADDRESS | DM_I2C_CHIP_WR_ADDRESS;
- return 0;
+ return sun8i_rsb_probe_chip(bus, chip->chip_addr, 0);
}
static const struct dm_i2c_ops sun8i_rsb_ops = {
--
2.33.1
