So multiple clients all reboot at the same time or just every different kind of ubnt gear you use at this particular location reboots when it associates. Either way.......sounds like u have done a clean install at this location so should work unless the ap is the problem. If its just one location off an Ap and you think the AP is good then even though you said you already have changed wires, poe, ect major stumpers like you are describing usually lead back to a wire in my exp or even possibly a poe. Id double check the wire tho if its isolated to one location and tried a handful of different cpe's
Sent from my Verizon, Samsung Galaxy smartphone -------- Original message --------From: Rory Conaway <r...@triadwireless.net> Date: 12/27/16 9:42 PM (GMT-06:00) To: Ubiquiti Users Group <ubnt_users@wispa.org> Subject: [Ubnt_users] Reboot problem when connecting to AP We tried 3 different PB400 nose cones, a NB19, and different versions of firmware from 5.6.2 to 5.6.9 and a couple of beta versions including v6.0 beta 15 and as soon as the client connects to the AP, the PB400’s and NB19’s reboot. We have used different cables, power supplies, etc… Putting on 6.0 right now but this is just weird. We have also tried multiple IP addresses in case there was an IP conflict. Any ideas are welcome. Rory Conaway • Triad Wireless • CEO 4226 S. 37th Street • Phoenix • AZ 85040 602-426-0542 r...@triadwireless.net www.triadwireless.net "I led the league in go get 'em next time." - Bob Uecker
_______________________________________________ Ubnt_users mailing list Ubnt_users@wispa.org http://lists.wispa.org/mailman/listinfo/ubnt_users
