Hi Everyone,
I'm a bit stuck and am not even sure where to go for help. I'm hoping
someone has the magic bullet that I'm missing.
I'm trying to connect an AIR/Flex App to a local install of ColdFusion
10 using Remote Object. I haven't done this in quite a while. This is a
brand new install of ColdFusion 10 [32 bit version] and Apache 2.2 [I
think is also 32 bit].
On the ColdFusion side; mylocaldomain.com/flex2gateway returns a 404
error. The old rule of thumb was that this meant things were not set up
properly. s
The "Enable Flash Remoting" checkbox is checked in the ColdFusion
administrator.
I tried tweaking the urlworkermap.properties for ColdFusion 10 as
described here:
http://inflagrantedelicto.memoryspiral.com/2012/12/flashservicesgateway-and-coldfusion-10/
and that had no affect.
I tried uncommenting the 'start flex 2' section of the web.xml as
mentioned here: https://forums.adobe.com/thread/1476011 and it had no
affect.
I've poured over various CF Config files and administrator settings
with no luck.
I set up a simple Flex/AIR to CF Sample; and the Flash Builder network
monitor response is a 404 error when calling the gateway.
I'm at a loss for what I should look at next; I remember this always
just working in the past.
Anyone have any ideas?
--
Jeffry Houser
Technical Entrepreneur
http://www.jeffryhouser.com
203-379-0773
