Did you try the CF forum? Looks like it is still active. https://forums.adobe.com/community/coldfusion
HTH, -Alex On 3/6/17, 7:53 PM, "Jeffry Houser" <jef...@dot-com-it.com> wrote: >Hi Everyone, > > I'm a bit stuck and am not even sure where to go for help. I'm hoping >someone has the magic bullet that I'm missing. > > I'm trying to connect an AIR/Flex App to a local install of ColdFusion >10 using Remote Object. I haven't done this in quite a while. This is a >brand new install of ColdFusion 10 [32 bit version] and Apache 2.2 [I >think is also 32 bit]. > > On the ColdFusion side; mylocaldomain.com/flex2gateway returns a 404 >error. The old rule of thumb was that this meant things were not set up >properly. s > > The "Enable Flash Remoting" checkbox is checked in the ColdFusion >administrator. > > I tried tweaking the urlworkermap.properties for ColdFusion 10 as >described here: >http://inflagrantedelicto.memoryspiral.com/2012/12/flashservicesgateway-an >d-coldfusion-10/ >and that had no affect. > > I tried uncommenting the 'start flex 2' section of the web.xml as >mentioned here: https://forums.adobe.com/thread/1476011 and it had no >affect. > > I've poured over various CF Config files and administrator settings >with no luck. > > I set up a simple Flex/AIR to CF Sample; and the Flash Builder network >monitor response is a 404 error when calling the gateway. > > I'm at a loss for what I should look at next; I remember this always >just working in the past. > > Anyone have any ideas? > > >-- >Jeffry Houser >Technical Entrepreneur >http://www.jeffryhouser.com >203-379-0773 >