On 07/12/2013 01:22 PM, Jason Keltz wrote:
On 12/07/2013 12:55 PM, Mike Burns wrote:
What IS a big deal is that every time I configure one network interface,
the others go back to "unconfigured". I'm told this is because I should
only configure one on the ovirt-node, and then use the engine to
configure the rest. Okay -- does it say that somewhere that I missed?
There should be a warning that configuring a new nic will disable
previously configured nics.
Nope.. no warning whatsoever...
Ah, bad memory on my part. It was there in an older release, but the
one you're running had a new UI framework and this was missed. It's
definitely something we will be adding back.
:) but when I'm in the engine, I can click on the node, and see that
it's up. I can click on network interfaces, and see that one is up, and
the other are down. I can create networks on the engine, and I can
assign the nodes interfaces to those networks, but for the life of me, I
can't figure out where I assign an IP to the nodes interfaces!! Surely,
the place to do that would be under the "Host" tab, yet it doesn't seem
to be there...
Host Tab -> Network Interfaces -> click on Setup Host Networks
On the popup, hover over the logical network (not the nic) and a
little pencil or pen (or some other graphic) that is used for
editing. Click on that and you'll get another popup where you can
choose static/dhcp and set gateway, ip and netmask.
Thank you *so* much! I did not see the little pencil!!!
Happy to help (and yes it was hard to see...)
Mike
Jason.
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
