On 12/07/2013 1:27 PM, Mike Burns wrote:
On 07/12/2013 01:22 PM, Jason Keltz wrote:
:) but when I'm in the engine, I can click on the node, and see that
it's up. I can click on network interfaces, and see that one is
up, and
the other are down. I can create networks on the engine, and I can
assign the nodes interfaces to those networks, but for the life of
me, I
can't figure out where I assign an IP to the nodes interfaces!!
Surely,
the place to do that would be under the "Host" tab, yet it doesn't
seem
to be there...
Host Tab -> Network Interfaces -> click on Setup Host Networks
On the popup, hover over the logical network (not the nic) and a
little pencil or pen (or some other graphic) that is used for
editing. Click on that and you'll get another popup where you can
choose static/dhcp and set gateway, ip and netmask.
Thank you *so* much! I did not see the little pencil!!!
Happy to help (and yes it was hard to see...)
Actually, Mike -- two of my networks were private and didn't need a
gateway... but two are public, and need a gateway! Unfortunately, the
interface seems to be missing that option!? It lets you configure an
IP, and a subnet mask, but where's the option for specifying a gateway
if you're specifying static addresses... (my guess is that it picks up
the gateway if you're using DHCP).
Jason.
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users