Hello together, recently I installed the whole UHD/GNU-Radio Toolchain on a fresh install of Kubuntu 18.04 LTS. I followed the instructions from https://kb.ettus.com/Getting_Started_with_RFNoC_Development and used the Pybombs install.
(I ran into a lot of problems there and had to install a lot of stuff manually because most of the commands were not working properly. Maybe the Pybombs Tutorial Section needs an update?) Finally I managed to install it successfully and the command uhd_config_version -- info prints: UHD 3.15.0.0-124-geb448043 (I also installed Vivado 2018.3 and added the License which seems to work.) After the install I wanted to validate it by creating an OOT Module and OOT Block named noc_block_checkdevprocess.v. I did not edit the Verilog Code because I only wanted to know if I was able to build an Image properly. (I ran the default Testbench too, which worked without errors.) The command to build my image is: ./uhd_image_builder.py checkdevprocess digital_gain -t X310_RFNOC_HG -d X310 -I /home/lskt/rfnoc-blocks_lskt/rfnoc with "rfnoc-blocks_lskt" beeing my OOT Module and "checkdevprocess" beeing my custom block. (I also tried the paths home/lskt/rfnoc-blocks_lskt/rfnoc/; home/lskt/rfnoc-blocks_lskt/; home/lskt/rfnoc-blocks_lskt/rfnoc/fpga-src ) Every single time I get the same error message: ERROR: [Synth 8-439] module 'noc_block_checkdevprocess' not found [/home/lskt/rfnoc/src/uhd-fpga/usrp3/top/x300/rfnoc_ce_auto_inst_x310.v:22] and I don't know why. I also tried the the uhd_image_builder_gui.py which did not even pop up until I uncommented the Line at row 149. I can see my OOT Block here after adding the Module in the gui, but it prints the same error message as the non-gui version. If you need further information to help please ask. Any help is appreciated. Felix _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
