On May 26, 2012, at 5:00 AM, [email protected] wrote:

> Message: 1
> Date: Fri, 25 May 2012 18:12:38 +0200
> From: Fred Schneider <[email protected]>
> To: Discussion of precise voltage measurement <[email protected]>
> Subject: [volt-nuts] Impedance bridge information
> 
> >>>
> Can someone give me a hint what to search for. For instance the right name of 
> such a bridge ( i think Z/Y or admittance cq impedance bridge) and what is 
> important so I can determ if they are for what I want and not just a allround 
> LCR bridge.
> 
> I want to measure the more extreme things like ESR, fF, delectric 
> proporties/losses ect but for most I love old precision measurement 
> instruments which make you think about what you do and have lots of knobs 
> instead of menus.
> 
> Fred PA4TIM

Hi Fred -- I think the best all-around (meaning most accurate when cal'd) 
manually-operated general bridge is the ESI 250DE. 4 digits resolution worst 
case with built in 1kHz oscillator and detector, and with DC source and 
detector for resistance. Mine is overall better than 0.1% on C and L, and runs 
about 0.03%or better  on resistance. ESI made all their own resistors and the 
Dekapot at the heart of the 250DE is just terrific. The range resistors on mine 
all checked better than 0.01% measured with my HP 3458A.

A good alternative is the GR 1656 -- but the 1650 and 650, etc are really not 
in this class, lacking an accurately readable dial.

Dick Moore
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.

Reply via email to