At what frequency do you want to measure your things? 1kHz, 1MHz, and 1GHz are VERY different.
-John =============== > > On May 26, 2012, at 5:00 AM, [email protected] wrote: > >> Message: 1 >> Date: Fri, 25 May 2012 18:12:38 +0200 >> From: Fred Schneider <[email protected]> >> To: Discussion of precise voltage measurement <[email protected]> >> Subject: [volt-nuts] Impedance bridge information >> >> >>> >> Can someone give me a hint what to search for. For instance the right >> name of such a bridge ( i think Z/Y or admittance cq impedance bridge) >> and what is important so I can determ if they are for what I want and >> not just a allround LCR bridge. >> >> I want to measure the more extreme things like ESR, fF, delectric >> proporties/losses ect but for most I love old precision measurement >> instruments which make you think about what you do and have lots of >> knobs instead of menus. >> >> Fred PA4TIM > > Hi Fred -- I think the best all-around (meaning most accurate when cal'd) > manually-operated general bridge is the ESI 250DE. 4 digits resolution > worst case with built in 1kHz oscillator and detector, and with DC source > and detector for resistance. Mine is overall better than 0.1% on C and L, > and runs about 0.03%or better on resistance. ESI made all their own > resistors and the Dekapot at the heart of the 250DE is just terrific. The > range resistors on mine all checked better than 0.01% measured with my HP > 3458A. > > A good alternative is the GR 1656 -- but the 1650 and 650, etc are really > not in this class, lacking an accurately readable dial. > > Dick Moore > _______________________________________________ > volt-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > > _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
