Mark, What language/development environment are you using to read 3458A memory?
On Thu, Aug 21, 2014 at 6:27 AM, J. L. Trantham <jlt...@att.net> wrote: > Mark, > > Would love to try it. > > I think the main reason to hang onto the calibration data is to be able to > send the meter to Keysight and find out if the meter was 'in spec' when it > arrived for calibration. If so, gives great confidence that the meter is a > 'good one'. > > Joe > > -----Original Message----- > From: volt-nuts-boun...@febo.com [mailto:volt-nuts-boun...@febo.com] On > Behalf Of Mark Sims > Sent: Thursday, August 21, 2014 1:53 AM > To: volt-nuts@febo.com > Subject: [volt-nuts] HP 3458A Mem test 1 hight. How do you read 32K memory > chips? > > I'm porting over my HP3458A NVRAM data dumper program to use John Miles > GPIBKIT routines. It should make it usable with most GPIB interfaces out > there and be able to run under more modern versions of Windoze. > My first crack at it is working, but it is quite a bit slower than my > original program. Not sure if anything can be done about that... BTW, my > program does verify the checksum bytes in the CAL ram so there is a check > that the dump went OK. Without Poul-Henning's work none of this would be > possible. > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts > and follow the instructions there. > -- *John Phillips* _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.