Just doing a search, here is an article discussing hydrogen permeation of Alumina at high temperatures. http://www.academia.edu/7323157/GAS_PERMEATION_PROPERTIES_OF_HYDROGEN_PERMEABLE_MACROPOROUS_ALUMINA_CERAMIC_MEMBRANES_AT_HIGH_TEMPERATURE
Of course this is about porous alumina membranes to purify hydrogen, but the effects of high temperature may apply to alumina in general porous or non-porous. On Wed, Dec 31, 2014 at 5:45 PM, James Bowery <jabow...@gmail.com> wrote: > > ---------- Forwarded message ---------- > From: Randy Mills rmi...@blacklightpower.com [SocietyforClassicalPhysics] > <societyforclassicalphys...@yahoogroups.com> > Date: Mon, Dec 29, 2014 at 7:51 AM > Subject: Re: [SocietyforClassicalPhysics] "a mixture of nickel and lithium > aluminum hydride" > To: "societyforclassicalphys...@yahoogroups.com" < > societyforclassicalphys...@yahoogroups.com> > > ...I think that it is a mistake to use a hydrogen porous vessel for a > hydrino reaction. > > On Wed, Dec 31, 2014 at 4:48 AM, <pjvannoor...@caiway.nl> wrote: > >> Probably at that temperature the hydrogen will leak very fast through >> the cell even if it is sealed properly >> >> Peter v Noorden >> >> *From:* Bob Higgins <rj.bob.higg...@gmail.com> >> *Sent:* Wednesday, December 31, 2014 5:36 AM >> *To:* vortex-l@eskimo.com >> *Subject:* Re: [Vo]:The MFMP replication effort live on youtube. >> >> Based on analysis of Lugano and Parkhomov work, excess heat begins at >> about 950C. The MFMP dogbone core was measured to be over 1200C and no >> excess heat was found. The likely suspect is that the glue used to seal >> the reactor tube failed, allowing a leak of the H2 when the LiAlH4 >> decomposed. The experiment was shut down because going higher in >> temperature risked burnout of the dogbone heater coil and the excess heat >> should already have been seen at a lower temperature than the 1200C core >> temperature that was achieved. >> >> Ryan Hunt is going to try again. We will try to contact Parkhomov to ask >> what cement he used to seal his reactor. We are also looking at ways to >> test the seals that we make. >> >> Bob Higgins >> >> On Tue, Dec 30, 2014 at 8:35 PM, Jed Rothwell <jedrothw...@gmail.com> >> wrote: >> >>> CB Sites <cbsit...@gmail.com> wrote: >>> >>> >>>> Wow, Replication fails. They had the "dog bone" so hot the steel >>>> stand holding it was white hot. But power in was equal to power out. No >>>> radiation. >>>> >>> >> >>> I have a hunch that was too hot. As the proverbial shaggy dog was too >>> shaggy, since we are using dog-related images here. >>> >>> - Jed >>> >>> >> >> > >