Jed,
I haven't seen the spec sheet m self, but this comment backs up what I
wrote earlier.
Where did you get the idea it would read high? From IH?
Ged <https://disqus.com/by/disqus_WZ8AEr6Uwu/> Obvious
<http://www.e-catworld.com/2016/08/06/industrial-heat-responds-to-rossis-complaints/#comment-2826803209>
Not a problem. Look at the spec sheet, it was used well within its
linear range at these temps. It's a good flow meter with great range,
and the spec sheet even quantitates the error on log scale for if you
use it out of range. It reports 3% less flow than in actuality if you
use it at -half- its lower rating point.
