If someone is looking for an analogy they could look at the behavior of a power 
transistor mounted on a heat sink.  For this exercise assume that the collector 
is directly connected to a power source.  Apply enough base drive to obtain a 
relatively large collector current.  

If you adjust the drive carefully you can reach a state of thermal run away 
within the transistor.  Now, think of the run away condition as the region 
where Rossi operates his ECAT.  Your job is to control the transistor collector 
temperature by modulating the base drive.   You are constrained to operation at 
a temperature that exceeds the initial run away point with full drive applied.

Carefully timed on - off drive to the transistor should be able to keep the 
temperature high, but limited.  If you mess up and let the transistor get too 
hot, then the current will continue to increase out of control and burn it up.

I have not done a careful analysis of this network, so I may have overlooked 
something about it behavior.  The general idea is that I am asking you to 
perform a difficult job similar to what Rossi faces.  Does this task look easy? 
 Can you keep the temperature constant by any fixed drive level when the 
temperature of the transistor is above the first threshold?  Positive feedback 
can be challenging.

Dave


-----Original Message-----
From: Jed Rothwell <[email protected]>
To: vortex-l <[email protected]>
Sent: Thu, May 30, 2013 4:11 pm
Subject: Re: [Vo]:Ethics of the E-Cat investigation put into question


          
    
Joshua Cude <[email protected]> wrote:
    
    
    
      
        
          
            
              
                
                  
                    
                      
A                        match is needed to ignite a firecracker, but           
             once ignited, the explosion sustains itself.
                      

                      
                      
A                        match is needed to start a campfire, but not to        
                sustain it. 
                      
                    
                  
                
              
            
          
        
      
    
    
    Cold fusion is not fire. It does not work the same way. Evidently,    
Rossi's reactor requires external stimulation to keep the reaction    under 
control. That's how it works. You cannot dictate to Mother    Nature how things 
must work. If you unplug a Rossi cell and try to    make it self-sustain 
without input, it will melt.
    
    An analogy to fire may be useful to understanding, but you cannot    
engineer a reactor based on analogies.
    
    - Jed
    
  

Reply via email to