We are using the layer 3 environment and I did have one initial problem
that's not in the upgrade notes. If you are using layer 3, your
controller management is on a different subnet, and your APs are
currently configured with statics addresses. Before you run the
conversion code (c1200-rcvk9w8-tar.123-11JX1), you must configure the AP
for dhcp. Reboot the AP, then run the upgrade code. If this is not
done, when the AP reboots from the upgrade it maintains that static ip,
therefore it never receives it's dhcp options 43 and 60.
James Nesbitt
Network Analyst
Duke University
Jorge Bodden wrote:
I was wondering if anyone out there has upgraded their Cisco 1200 APs
to the code that is supposed to do LWAPP? I have looked at the
documentation that Cisco provide. But I did not find anything about
the setup. Does it work at layer 3 or layer 2? Do you still let the
APs that IP address of the controllers through option 43 or is there
some other mechanism? Any help on this matter would be greatly
appreciated. Thanks
Jorge Bodden
--------------------
This electronic message is intended to be for the use only of the
named recipient, and may contain information that is confidential or
privileged. If you are not the intended recipient, you are hereby
notified that any disclosure, copying, distribution or use of the
contents of this message is strictly prohibited. If you have received
this message in error or are not the named recipient, please notify us
immediately by contacting the sender at the electronic mail address
noted above, and delete and destroy all copies of this message. Thank
you.
**********
Participation and subscription information for this EDUCAUSE
Constituent Group discussion list can be found at
http://www.educause.edu/groups/.
**********
Participation and subscription information for this EDUCAUSE Constituent Group
discussion list can be found at http://www.educause.edu/groups/.
