Few more tips- >From the console watch for the LWAPP Discovery, then the LWAPP Join. Chances are, you'll have to manually pull in the SSC on these before you'll get the join. if you never see the Join, you may have an IP address in the AP but it won't work.
And- to make things even more interesting- I have the occasional older AP that just leaves it's controller now and then, gives the "cannot associate with the SSC provided". Then it'll come back hours or days later- lots of interesting aspects to the system, for sure. Lee Lee Badman Network/Wireless Engineer 315 443-3003 >>> [EMAIL PROTECTED] 2/28/2007 1:02 PM >>> All, How does one know if the upgrade was successful. I am able to see the AP come up. But I do not see it anywhere on WCS, via MAC or hostname? Thanks. Jorge Bodden James Nesbitt wrote: > We are using the layer 3 environment and I did have one initial > problem that's not in the upgrade notes. If you are using layer 3, > your controller management is on a different subnet, and your APs are > currently configured with statics addresses. Before you run the > conversion code (c1200-rcvk9w8-tar.123-11JX1), you must configure the > AP for dhcp. Reboot the AP, then run the upgrade code. If this is > not done, when the AP reboots from the upgrade it maintains that > static ip, therefore it never receives it's dhcp options 43 and 60. > > James Nesbitt > Network Analyst > Duke University > > > Jorge Bodden wrote: >> I was wondering if anyone out there has upgraded their Cisco 1200 APs >> to the code that is supposed to do LWAPP? I have looked at the >> documentation that Cisco provide. But I did not find anything about >> the setup. Does it work at layer 3 or layer 2? Do you still let the >> APs that IP address of the controllers through option 43 or is there >> some other mechanism? Any help on this matter would be greatly >> appreciated. Thanks >> >> Jorge Bodden >> >> >> >> -------------------- >> >> This electronic message is intended to be for the use only of the >> named recipient, and may contain information that is confidential or >> privileged. If you are not the intended recipient, you are hereby >> notified that any disclosure, copying, distribution or use of the >> contents of this message is strictly prohibited. If you have >> received this message in error or are not the named recipient, please >> notify us immediately by contacting the sender at the electronic mail >> address noted above, and delete and destroy all copies of this >> message. Thank you. >> >> ********** >> Participation and subscription information for this EDUCAUSE >> Constituent Group discussion list can be found at >> http://www.educause.edu/groups/. > > ********** > Participation and subscription information for this EDUCAUSE > Constituent Group discussion list can be found at > http://www.educause.edu/groups/. -------------------- This electronic message is intended to be for the use only of the named recipient, and may contain information that is confidential or privileged. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or use of the contents of this message is strictly prohibited. If you have received this message in error or are not the named recipient, please notify us immediately by contacting the sender at the electronic mail address noted above, and delete and destroy all copies of this message. Thank you. ********** Participation and subscription information for this EDUCAUSE Constituent Group discussion list can be found at http://www.educause.edu/groups/. ********** Participation and subscription information for this EDUCAUSE Constituent Group discussion list can be found at http://www.educause.edu/groups/.
