I ssh'd into a radio and tried the command: telnet <ip of AC> 9080 Nothing.
Is that the proper command? -----Original Message----- From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] On Behalf Of Kristian Hoffmann Sent: Wednesday, October 19, 2011 11:40 AM To: wireless@wispa.org Subject: Re: [WISPA] Aircontrol for UBNT On 10/19/2011 09:17 AM, Ryan Spott wrote: > Admin Tab -> System Settings -> Air Control Server Address > Make sure this is an IP address. If not then your CPE will fail to talk > to your server. It obviously needs to be the wan port of your router. Just as a quick test, you can ssh to a managed Ubnt device, and run the following... telnet <Air Control Server Address> 9080 GET /<enter> <enter> If you see a HTTP header response, then you're good. If you get a blank stare, then you have a firewall problem, such as what Ryan alluded to. -- Kristian Hoffmann System Administrator kh...@fire2wire.com http://www.fire2wire.com Office - 209-543-1800 | Fax - 209-545-1469 | Toll Free - 800-905-FIRE ------------------------------------------------------------------------ -------- WISPA Wants You! Join today! http://signup.wispa.org/ ------------------------------------------------------------------------ -------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/