The auto sequencer, while it should not have gone back to TX2, actually acted in a benign manner compared to what I would have done manually, namely ended the contact without the benefit of logging it.
73 de Bill ND0B -----Original Message----- From: Jay Hainline Sent: Monday, August 24, 2015 6:56 AM To: wsjt-devel@lists.sourceforge.net Subject: [wsjt-devel] sending RR73 message on JT9H with auto sequencer I had a small issue this morning working a station on 6 meters using WSJTX-devel r5808 using JT9H mode and auto sequencing. The station I was running with sent calls followed by RR73 programmed in the TX4 message button. The auto sequencer on my end got confused by this and went back to TX2 to send the report again. I was wondering if this is something where the auto sequencer can be programmed to be a little more flexible? I think if I copy either RRR or RR73, it should go to transmit TX5 which I have as sending calls and 73. The station I ran with says he is using version r5803 and claims RR73 was pre-set for TX4 inside that particular version he downloaded. My WSJTX 1.6.1 copy has always had TX4 programmed with calls and RRR. 73 Jay Jay Hainline KA9CFD Colchester, IL EN40om ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel