On 02/07/2017 17:13, Dan Malcolm wrote:
I just compiled r7776 and found that there is a “split” problem. In
Settings under the Radio tab I have enabled Rig for Split Operation.
I am running Kenwood TS-2000 for the Rig model. That setting has been
working well until I compiled the new WSJT-X 1.7.1-devel r7776. Prior
to this Tx occurred on the B CFO at 14.78.500Mhz. Now it is still
using the B VFO but no offset occurs. I may have confused things a
bit because I also recompiled HamLIb3.
Dan Malcolm
K4SHQ
Hi Dan,
the Tx VFO dial frequency is not fixed, it depends on the Tx DF you
select. If you control-click around the waterfall you should see that
each 500Hz section uses a different Tx VFO dial frequency. That is
assuming you are using one of the multi-decode modes JT9, JT65 or FT8.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
